Catches & Latches

Home | Catches & Latches | Door Hold-Back with Inside/Outside Release

Door Hold-Back with Inside/Outside Release

A circular hold-back with rotary action, this model has 'jaws' that can be released by levers on both inside and outside. Made in tough, self-coloured moulded materials, it is flange-fitted through three holes to a metal panel and the striker pin is attached to door or window, with a moulded 'buffer' to cushion impact.

These hold-backs are used on tractor and similar machines to hold doors and windows firmly against the side of the cab. Similar models are available for all-glass panels.

Ordering Code

9/01958	Rotary holdback and striker, panel fixing
9/01954	Rotary holdback and striker, for glass fixing

Specification

All dimensions shown are rounded to the nearest millimetre. Please request a drawing for the exact product specific and tolerances.

A	Total depth	52 mm
B	Body diameter	44 mm
C	Striker body projection	18 mm
D	Striker piercing (dia)	16 mm
E	Fixing holes (dia)	54 mm
H	Hole sizes (dia)	6 mm

Note: Holdback & striker are designed tosuit 3mm-thick panels.

As the unit is slammed, the striker pin causes two sprung pins to separate and then close again behind the shaped 'nose'. Action of the operating levers will release the pins, and a sprung central plunger ensures the striker pin is ejected.
Inside or outside release levers are rotated in either direction through approximately 15 degrees to disengage striker pin.
Unit is mounted from outside through a circular aperture and is fixed through three equi-distant mounting holes. A gasket is supplied. Striker pin is secured by single hexagon bolt at rear, also with gasket.
Unit is self-coloured with textured black finish. Striker pin, 'jaws' and entry sleeve are bright nickel-plated.
'O'-ring fixing through varying glass thickness. With/without exterior release lever. Striker pin/buffer length variable.

Catches & Latches

Door Hold-Back with Inside/Outside Release

Ordering Code

Specification

Get in touch today!